Calling all Girl Scouts! Who is getting ready for camp? Need Trading Pins, but don't know where to start?  Check out our fun 15 min or less project!!! All you need is a Mod Melter, High Temp Mini Mod Melts, Mod Molds, Beacon 3-in-1 Adhesive and pin blanks.  We found all of our supplies at Michaels.  Plaid Beacon Adhesives

We said it before friends, but we will say it again! You can create from start to finish your Trading Pins in 15 min or less.  To get started gather all of your supplies.  Take your Mod Melter and plug it in, turn on the switch (Caution this gets hot!) next take out your Mold and your Mod Melts. Place the Mod Melt into the Mod Melter and get started.

Fill each mold with the Mod Melter Sticks and allow ten minutes to dry.  It is ok that they are not perfect on the back, you can trim off excess melt with scissors.  

After you have allowed them to dry, tip over your melt and pop out each little piece. (They come out super easy)  Trim off any excess Melt with your scissors like we stated above. Next get our your 3-in-1 Beacon Adhesive and your Pin blanks.

Place a small amount of glue onto the back of the pin blank and adhere to the Mod Melt.  Allow a couple of minutes of drying time.

We also added a few magnets to the back of some in case your aren't wanting to trade pins.  Aren't you just loving how these turned out??

Here are a few of the pins that we created today! Have fun at camp! Whoop Whoop!! 

Have you been afraid to dabble in Mixed Media? Well put your big kid pants on! Midge and Madge are bringing you a series of Mixed Media tips and tricks. Starting with this episode on modeling paste. Be sure to watch the episode HERE to see what all of the hype is about!!! 
​

P.S. Are you ready to get your hands dirty and start playing with Modeling Paste??? Be sure to leave your comments below to be entered to win a fabulous prize!!! Also remember to follow us on Instagram @midgeandmadgedmingle Whoop Whoop!!!